3d printer pen with LCD screen
Model No.:CWSG60920
Description
Output Materials Type: Fused Deposition Modeling
Molding Method: 3D Modeling
Printing Area: Unlimited
Input: AC 110V-240V
Output: DC 12V 3A
Nozzle Diameter: 0.7-0.4mm
Filament Diameter:1.75 mm
Sprinkle Speed: Adjustable
Heating Temperature: 160 to 250 Degree Celsius (Adjustable)
Dimensions: 220 x 170 x 70 mm
Wight:62 g
Package weight:420 g
Advantages of our pen is patented nozzle- no burning damage risk ( eariler than 3d doodle) ,lightweight and beautiful surface, high-quality PCB (cooperated with Myriwell), Safe and funnly thanks to its fast cool technology.
Temperature adjustable. ABS/PLA filaments available, colorful drawing will be more attractive
3d pen is a creative indoor and outdoor toy, Chrismas gift or Birthday gift.
An excellent tool for making crafts, home decor, gifts, and much more. The masterpieces draw out by the pen can used for home deco, the time u spend with your kids& your friends & family& yourself , which can also be a wonderful memory.
How to use?
Step 1: Connect your 3D pen to the power adaptor
Connect the power adaptor to the back of the 3D pen and plug it into a power source.
When the yellow LED turns on, the pen is in the preheat status.
Step 2: Allow your 3D pen to heat up before loading filament
Press the “wire feeding” button, so the red LED turns on. After 30 seconds, the red LED will turn into green, preheating is done and the pen is ready.
Step3: Load the pen
Insert the ABS/PAL filament into the “wire loading hole” which is at the end of the pen. Keep on
pressing the “wire feeding” button, the material will be loaded by built-in motor. Hold till the
plastic material comes out from the nozzle nip, so the material loading is finished.
Step4: Draw &adjust your speed
Keep pressing the wire feeding button and draw your 3D objects. The speed of extrusion is
adjustable by speed controller. Releasing the button will cause the pen to stop extruding.
NOTE :The device will switch to standby mode if not being used over 5minutes. The LED light
will be off. If you want to use it again, press the“wire feeding”button to restart.
Step5: Unloading Filament
When you want to unload or change the filament, you should press the wire unloading button,
You may need to adjust the speed controller.
Warning:
This 3d pen printer is suitable for children over 8 years old and adult use, Children should use it under the tutelage of adult.
*The 3d pen nib and the near area are dangerous high temperature area, do not touch the nib with hands or touch others objects with the nib.
*Do not block the wire loading hole with foreign body.
Contact us:
Email:sales@cto.hk
Address:Floor 8, Huguangtong BLD,Longgang Road,Longgang,Shenzhen, China
Telphone: +86-755-25608673